PANEL:

• NEMA 4X fiberglass enclosure: dead front with inner door
• UL 508A listing on control panel
• IEC horsepower rated starters, with motor protective switch IEC contactor and overload protection
• Fused control circuit transformer
• HAND/OFF/AUTO switches (heavy duty 22 mm)
• High water and low water pilot lights (22 mm)
• High water alarm beacon and horn for visual/audio warning
• Alarm Test/Normal/Silence Switch
• Auxiliary high water alarm contact
• Submersible pressure transducer with a 6 psi (13.8’ [4 m]) operating range, 40’ (12 m) cable and 1/2” NPT rigid conduit connections.
• Two back-up floats: low level cutout and high level alarm (not included)
• Moisture detection monitoring circuitry

CONTROLLER:

• 4-20 mA level input with configurable zero and span (The unit of measure is configurable to feet, inches, and percentage or metric.)
• 20 segment bar graph display of wet well level
• Six programmable level set points (high water alarm, start lag pump, start lead pump, stop lag pump, stop lead pump, low level alarm)
• Alpha-numeric LED for process value display and program parameters
• Pump over temperature indication (Two modes: Lock Out Pump with Auto Reset, Lock Out Pump with Manual Reset
• Seal-fail indication (Three modes: Indication Only, Lock Out Pump with Manual Reset, Run Pump as Lag Only)
• High level and low level indication (Two modes: Auto or Manual Reset)
• Elapsed time meter and cycle counter for each pump
• Pump alternation (Auto/1-2/2-1 selectable)
• Lag pump start delay (programmable 1-600 seconds)
  

OPTIONS:

• Alarm beacon flasher
• NEMA 3R steel enclosure
• Pump run dry contacts
• NEMA 4x stainless steel enclosure
• Lightning arrestor
• Automatic reversing (grinder pump only)
• Anti-condensation heater
• Intrinsically-safe relays for back-up floats
• Extended transducer operating range and cable length